2 Scrapbook Border Ideas for Spring Using Full Bloom

Looking for fresh ideas for your spring scrapbook layouts? Well, look no further – we’ve got two spring scrapbook border ideas using Full Bloom that you’re going to love! They’re boisterous and fun and will take your spring and floral layouts to the next level… Sound like something you’d like to create? Read on! 

Supplies You’ll Need to Make These Borders:

• Full Bloom Paper Pack
• The Original Border Maker System
• Scallop Dot Border Maker Cartridge
• Sprout Border Maker Cartridge
• Dewdrop Flower Punch
• Scallop Burst Border Punch
• Embossed Trio Flower Punch
• 12-inch Trimmer
• Tape Runner
• Repositionable Tape Runner Refill
• Foam Squares

Border 1:

Step 1: Cut a piece of floral patterned paper to measure 1-1/2″ x 12″ for the base for this border.

Step 2: Using the Scallop Dot Border Maker Cartridge, punch both sides of a purple strip of paper. Trim the scalloped edges off to both measure 5/8″.

Step 3: Again, using the Scallop Dot Border Maker Cartridge, punch both sides of a blue strip of paper. Trim the scalloped edges off so both measure 7/8″.

Step 4: Adhere the purple scalloped strips on top of the blue scalloped strips. Apply adhesive to the long edges of the floral strip and attach the scalloped edges of the purple/blue borders on either side as shown. The border should now measure about 2-3/4″ x 12″.

Step 5: Punch three flowers from a piece of blue paper using the Dewdrop Flower Punch. Punch four times with the Embossed Trio Flower Punch and the floral paper. Set aside all but three small yellow circles. Place the circles on the dewdrop flowers and mount to the border as shown with Foam Squares.

Border 2:

Step 1: Cut a piece of pink patterned paper to measure 1-3/8″ x 12″ for the base of the border.

Step 2: Using the Scallop Burst Border Punch, punch along one long edge of the green eucalyptus paper. Cut the piece to measure 2″ x 12″.

Step 3: Adhere scalloped edge to the purple strip, creating a border approximately 2-1/2″ x 12″.

Step 4: Using the Sprout Border Maker Cartridge, punch a border with the Evergreen Cardstock. Adhere to the border as shown.

Step 5: Adhere yellow and floral embossed trio flowers along the sprout vine as desired, using Foam Squares on some for added dimension.

Happy Creating!